MaxFil Pressure Filtration Device
Our new Teflon-coated Aluminum design is durable
The MaxFil is specifically designed to meet the demands of the Toxicity
Characteristic Leaching Procedure. Design features built into this hazardous waste
filtration system make complying with Method 1311 easy and efficient. No splitting
of the sample extract is necessary because the 2200mL capacity allows the analyst
to load the entire sample before filtration begins. This not only saves time but also
reduces the supplies necessary to prepare a sample. Pressurization is achieved
by use of a quick connect fitting instead of a cumbersome hose-barb fitting. This
quick-connect requires no clamping and, unlike a barbed fitting, it cannot "blow
off" during filtration. All pressures are monitored by a pressure gauge located on
the top plate of the MaxFil. When used with a regulator, filtration can be performed
accurately and precisely without constant attention by the analyst.
Sample materials may be introduced into the MaxFil by removing the top plate or
through the 1" diameter entry port. This unique entry port has a two-inch knurled
handle that enables any analyst to open and close the port without the use of tools.
All wetted surfaces of the Maxfil are Teflon-coated to offer extra assurance that no
leaching of metals will occur.
Teflon-coated MaxFil PF000-2
A. 1/4" female disconnect
B. 1/4" male disconnect
C. 1" entry port handle
D. Top plate
E. Bottom plate
F. Viton-A cylinder O-ring
G. Pressure gauge, 0-100 psi
H. Connecting rod
J. 142mm filter support screen
K. Exhaust port
L. Thermoplastic locking handle, 3 pk
M. 1/8" pressure relief valve
O. Viton-A inlet O-ring
Previous Page - Next Page
-Laboratory Products Ltd.
Choose a different catalog.